Note number for example: xx4įlashes quickly 1 to 2 times.
Note number for example: x2xįlashes quickly 1 to 4 times.
Note number for example: 1xxįlashes quickly 1 to 4 times. Light ON for 3 seconds (Start of Fault Codes)įlashes quickly 1 to 4 times. If everything is done correctly, it should display as follows:įlashes quickly 1 to _ times depending on number of faults Make sure the jumper wire has a good connection with the pins.Ĥ.) Go in your car and turn the ignition to ON in one quick movement.ĥ.) Look at your SRS/Airbag Light and watch the flashes. Open your hood, and locate the diagnostic connector and unscrew the top.Ģ.) Inside the diagnostic connector, locate pin #1 and pin #6.ģ.) Take your jumper wire and jump pin #1 and pin #6. They will either need to jump the pins, or will be able to read the flashing light (similar to reading check engine light codes).ġ.) Make sure your ignition is turned off. Something around 5inches long.Ģ.) A Friend - Someone that you trust, and is competent. This has worked on a 1990 and a 1991 3.25i.ġ.) Jumper wire - Nothing too long since you will be jumping pins at your Diagnostic Connector. This is the 1st write up for GETTING and RESETTING Airbag Codes/SRS Light. Don't rip this write up off from me, I worked hard doing this as a favor to the e30 community. Some of the images were used from AllDataPro. If you want to do this correctly, go buy the proper tool or take your car to a professional. What happens or breaks on your car while you're doing this is your own fault. Disclaimer: This information is used from AllDataPro.
0 kommentar(er)
